I went to Kinko's and had them print out the dash schematic that I am working on in Google Sketch Up. They printed it actual size so that I could "play drive" in the jeep to see how I want the dash.
Currently, I think the stereo is too far and the modular switch panel is a little too large. So I will make the panel smaller and see if I can squeeze the radio over. I also need to position the wipers, heater control, and the light switch.
I am going to move some switches and then focus on where I am putting some of the indicator lights on the dash, then I should have everything I want. Hopefully I'll finish designing by the end of tomorrow and can start fabrication by the middle of the week.
